[. . . ] To fully benefit from the support that Philips AVENT offers, register your product at www. This combined steamer and blender is particularly suitable for preparing small amounts of baby food. The combined steamer and blender supports all parents in preparing fresh meals for their babies with a simple steaming and blending function combined in one appliance. 1) a B C D E F g h i J k l m n Lid with steam hole Valve Sieve Blade unit Jar with blade unit holder Steam outlet on motor unit Locking area for handle Filling opening of water tank Motor unit Steaming light Control knob Bottom of the appliance with mains cord Measuring cup Spatula important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] Wait 2 minutes until no more steam comes out of the steam outlet, to avoid scalding by hot steam. If you want to serve the steamed baby food without blending it, test the food on the back of your hand to make sure it is at a safe temperature for your baby. Note: If you want to steam another batch of ingredients, let the appliance cool down for 10 minutes before you start steaming again. 10 If you want to proceed with blending the steamed food, follow the instructions in section `Blending after steaming' below. 11 Under normal conditions, no water remains behind in the water tank after steaming. In case of scale build-up inside the water tank, interruption of the steaming process or unintended use), some water could remain behind in the water tank. In this case, empty the water tank completely after use to avoid bacterial growth. to descale the water tank , see chapter `Cleaning and maintenance'. Blending after steaming 1 Grab the jar handle and lift the jar off the motor unit. Turn the jar around and shake it so that the food falls down onto the blade unit (Fig. Always make sure that the lid has cooled down after steaming before you open it to add more ingredients (do not exceed the maximum level indication) or to remove the remaining water from the water tank. After you have put liquids in the jar, never put the jar in the steaming position. Make sure the handle is on the right-hand side and positioned between the two ridges of the locking area (Fig. Hold the knob in this position until the food is properly blended (Fig. If you have not finished blending after 30 seconds, switch off the appliance and wait a few seconds before you continue. If the appliance becomes hot, let it cool down for a few minutes before you continue. Note: If the ingredients stick to the wall of the jar, switch off the appliance and loosen them with the spatula or add some liquid. Note: Make sure that the blended baby food has the right consistency (e. 8 Under normal conditions, no water remains behind in the water tank after steaming. In case of scale build-up inside the water tank, interruption of the steaming process or unintended use), some water could remain behind in the water tank. If you have not finished blending after 30 seconds, switch off the appliance and wait a few seconds before you continue. If the motor unit becomes hot, let it cool down for a few minutes before you continue. [. . . ] If the appliance continues to give off this smell after you have used it a few times, check whether the processing quantity and processing time are correct. Possible cause You put too much food in the jar or you let the appliance blend too long. Solution Process smaller quantities and do not let the appliance blend for more than 30 seconds at a time. Problem The appliance continues to give off an unpleasant smell after I used it a few times. [. . . ]